The Carbon Cutter is installed after the DG exhaust (muffler/silencer). No modification to the exhaust is required.
Flue gas enters the Carbon Cutter and is confronted with Corona discharge.
Due to the contact with high voltage, the surface charge of the PM is nullified and PM gets attracted to electrodes of opposite charge. And the size of the PM increases beyond PM 10.
The PM agglomerated PM is collected in powder form and is available for reuse.
Energy efficient as requires no active regeneration. No dependency on exhaust temperature.
Robustness to wide variety and condition of in-use DG sets. Remote installation possible
Unmatched and minimal flow restriction compared to conventional technologies.
No additional fuel consumption penalty.
Simple, efficient and Robust design that gives consistent performance and long operational life.
No secondary emissions, face plugging, hydrothermal aging or substrate/filter damage risk.
